December 18, 2009 Report on Exhibition in India. On the 25-29 of November, 2009 "The 5th International Construction Equipment and Construction Technology Trade Fair" took place in Bangalore International Exhibition Centre (BIEC). More >>
September 26, 2008. Dealer seminar. The sales seminar that took place on the 23-24th of September, 2008 in Tula Science and Technology House was a serious step of "Stroymechanika" Ltd in development of dealers network. 19 organizations from all parts of Russia as well as from Belorussia, Kazakhstan participated in this seminar.More >> March 25, 2008 The new bag unloading station with batching system SRD 500 LOGIC has been put into operation. More >> March 20, 2008 The production of screw conveyors of VK 114, VK 159 type, up to 9 meters by length, of VK 219, VK 273 up to 12 meters by length. More >> March 18, 2008 The production of new crew conveyers of new type VK 114, VK 219. More >>
Bucket elevators (noria) of "EKL" series by the engineering enterprise «Stroymechanika» are designed for continuous transportation of bulk materials of volume weight up to 3500 kg/m? inclusively such as sand, gravel, crushed stone, peat, slag, coal and etc. in the production of construction materials on the chemical, metallurgical, engineering enterprises, on coal-cleaning plants and other branches of industry. The elevators are used only to lift cargos from initial up to end point without intermediate loadings and unloading.
The application of the elevator as a conveying unit helps to install compact conveying systems occupied small sites.
Norias consists of conveying device with fixed buckets driving and loading devices, loading and unloading boots with branch pipes and a casing. The reliable gear motor drives the elevator. The execution of elevator can be left-installed or right-installed drive (installation from the side of loading branch pipe). The designs of elevator (noria) provides a brake or stop to prevent the spontaneous backward running of working part.
The steel housing with loading and unloading branch pipe plays role as a supporting part and protection against environmental attack on material.
The bulk material is loaded the bottom of the elevator (loading boot end) through loading branch and enters the buckets then, it goes vertically and enters the tank throughout unloading elevator branch throughout loading branch installed on the top (unloading boot end) due to centrifugal force created by drive pulley. The empty overturned buckets return to the low section, after that the cycle repeats.
At loading the homogeneous supply of material should be provided, as the movable pulley can be jammed at overload that undoubtedly it will lead to the stop of noria.
? Simplicity and structural reliability;
? Access hatchs;
? Lining of the bottom of loading boot that provides the friction decrease and power costs accordingly;
? Application of metallic and wear resistant polymer buckets;
? Wide range of capacity;
? Application of reliable components of well-known manufacturers:
- belt of (SAVA, Slovenia). Standard elevators are supplied with belt of general purpose for conveying of materials with temperature no more than 60°С. At conveyance of materials with higher temperature the elevator is equipped with heat-proof belt (up to 200°С);
- gear motors of (BONFIGLIOLI RIDUTTORI, Italy).